Goku Should Have Long Hair Again

Download Article

Download Article

Dragon Ball Z is an old school anime, well-known for its fight scenes and spikey hairstyles. Most anime hairstyles are hard enough to translate into existent life, and the gravity-defying spikes of Dragon Ball Z are no exception. Luckily, wigs can practice things that real pilus tin can't do. With the assistance of some foam, wefts, glue, and lots of hairspray, you can get your wig to look similar Goku's!

Things You Should Know

• Unless your hair is really long, it's really pretty difficult to simulate that Goku look and you're probably better off getting a wig.
• So long equally you have four larger spikes on the right side well-nigh the front and two slightly smaller spikes near the back on the left, it should read visually like Goku'southward hair.
• If you're styling actual hair, use hairspray as the base of operations product and holding gel for the tips of each spike to keep them from falling down over time.
• Goku's bangs look really large in the anime, merely you don't desire to totally cover your brow up IRL or information technology will just expect like regular spiky hair.

1. ane

   Print out reference images. Y'all should accept one of Goku's hair from the front end, side, and dorsum. One taken at an angle would also help. Brand certain that the images are nice and clear. Keep these images handy; you will demand to refer to them throughout the wig styling process.

   • If you lot don't accept a printer, take the images readily available on your computer, tablet, phone, etc.

2. two

   Get a short, black wig. Expect for a brusk, black wig with finger-length hair that is hands fasten-able. Something with "J-rock" in the name and lots of layers would exist ideal.^[i]

   Advertising

3. 3

   Pivot the wig to a Styrofoam wig head. You tin can exercise this with regular sewing pins or T-pins. Side by side, place the wig caput onto a stand up. You tin can easily make your ain by sticking a thick dowel into a bucket filled with sand or pebbles, then placing the wig head on top.

   • If you are using a dowel, make sure that it is sparse enough to fit into the pigsty at the bottom of the wig caput.

4. four

   Sculpt the bangs into large, triangular spikes. You will need two big spikes to either side of the forehead, and ii smaller ones on each temple. The bangs need to lay flat across the forehead. Refer to your reference pictures for a clearer image. To make the spikes, practise the following:^[2]

   • Get together a department of hair from the bangs.
   • Compression the bottom of the section so that it tapers into a triangle.
   • Mist the section with hairspray.
   • Set the triangle with a hair drier.

5. 5

   Touch up the spikes. Utilise a small pair of scissors to trim off any unruly or stray hairs. If the spikes are separating at the tips, you tin can apply a piddling bit of hair gel or a clear-drying glue to the points. This volition assistance them concord together.

   Advertising

1. one

   Brand five cones out of craft form for the spikes. Cut five, large triangles out of craft foam. Gyre each ane into a cone, then secure it with hot glue. The cones need to exist about the same height as your face.^[3] Don't worry if they wait too big; yous will trim them downwards later.

   • Trace the triangles onto black felt before gluing them together. Relieve the triangles for the next step.

2. 2

   Cover the arts and crafts foam with black felt. This will help the hair blend in meliorate. Wrap the felt triangles effectually the craft cream cones, and secure the edges with hot glue.^[four] If y'all did not cutting the triangles out of black felt earlier, simply comprehend the cones with the felt, then trim off the backlog felt off the sides.

3. 3

   Grade the cone bases into oval shapes. The spikes volition look more realistic if they have an oval base rather than a round one. Describe a ring of hot glue around the base of your showtime cone, then squash it into an oval while information technology dries. Practice this for all of the cones; work i cone at a fourth dimension, otherwise the glue volition ready upwardly too fast.

4. 4

   Secure the spikes to the wig to test them out. Place two spikes on the left side of the head, with the lesser and meridian edges touching. Side by side, place 2 spikes on the right side of the head, and a 3rd spike directly in a higher place. Make sure that their edges are touching likewise.^[five]

   • Orient the spikes vertically, with the narrow ends of the ovals facing upwardly/down, and the long edges facing forepart/back.
   • Identify the spikes backside the ears.

5. 5

   Check the spikes confronting your reference image. Make sure that they are in the right position. If one of the spikes appears too big, accept it off and cut downward the bottom edge. Continue doing this until you are satisfied with the size. Once y'all are happy, remove the spikes, and label them on the inside with a black marker.

   • If yous used black foam, use a white, silver, or gold mark instead.

   Advertisement

1. 1

   Get some black wig hair. You lot tin can buy a hank of loose hair or wefted wig hair extensions. Make sure that you get the same shade of black as your wig. There volition be a divergence between black-black and soft-black. Do non get braiding hair or "Jumbo Braid" kanekalon; it is too crinkly.

   • Plan on getting three packs. Alternatively, you can cut the wefts off of a long wig instead.

2. 2

   Cut the hair until it is a little longer than the cones. If you bought the pilus in hanks, divide it into pencil-sparse bundles showtime, and then tie it around the heart with twist ties. If y'all bought wefted hair, cut the wefts down to 1 to ii inches (2.54 to 5.08 centimeters) wide. Measure the hair confronting the cones, then cut it down until it is about 2 inches (5.08 centimeters) longer than the cones.

3. 3

   Glue the weft to the cone with cloth gum or tacky glue. Spread some mucilage onto the cone, then press the wig hair into the glue, with the tied/wefted border facing down. Use your fingers to spread the hairs as thinly as y'all tin can beyond the glue.^[6]

   • You desire the lesser tied/wefted border of the hair extending past the bottom border of the cone by most 1 inch (two.54 centimeters).

4. 4

   Secure the lesser edge of the hair to the inside of the cone. Depict a line of hot glue within the cone, shut to the border. Fold the lesser of the hair over the edge of the cone and printing information technology into the glue. Y'all tin practise this with a pen or paintbrush handle if the mucilage is too hot.^[7]

   • If you tied your hair at the bottom, cut the hair apart and remove the twist tie before you mucilage it down.
   • Use a low-temp hot gum gun so that y'all don't burn down yourself.

5. 5

   Set the hair with hairspray and a hair drier. Holding the pilus down, lightly mist it with a strong hold hairspray. Heat the hair with a hair drier until the glue and hairspray dry.^[8]

6. 6

   Echo the process for the rest of the cone. A single weft or bundle wouldn't be enough to cover the unabridged cone. You'll have to repeat the last couple of steps a few times until you accept the entire cone covered.

7. 7

   Trim and glue the tip of the cone. Apply a generous corporeality of gum to the tip of the cone, then smooth the hair down then that it sticks. Once the gum has dried, you lot tin trim the hair into a finer point. Be conscientious non to cutting abroad the cream, however!^[nine]

8. 8

   Repeat the process for the other cone. Information technology would exist a good thought to go on the cones labeled. You lot can do this by placing them onto a sheet of paper with their position on the wig written underneath.

   Advertisement

1. 1

   Put your hair under a wig cap, and so put the wig on. Most Styrofoam wig heads are much smaller than human heads. Unless you lot know that your head is the same size as the wig head, you will need to do the side by side step directly on your head.

2. 2

   Hot glue the spikes to the wig. Exercise this in front of a mirror with your reference pictures on hand. Call up, you lot volition demand iii spikes on the right and two on the left. Position them vertically upwardly the sides of your head, behind your ears.^[10]

   • Keep in mind that things are reversed in the mirror.
   • If this is too scary for yous, pall a thin towel over the wig head, cover it with the wig cap, then put the wig on top.

3. 3

   Remove the wig and sew together the spikes on. Once you have the spikes glued on, pull the wig off. Thread a curved needle with black thread, then sew the spikes on. Make sure that you are sewing the spikes right into the wig's cap. If you sew just to the hair, the spikes volition fall off.^[11]

4. 4

   Blend the spikes into the wig. Pin the wig onto the Styrofoam wig caput. Accept a few strands of hair from the wig, and polish them onto the get-go spike. Set the hair with hairspray and a hair drier. Practice this downward the front side of all the spikes, then the top and back.

5. 5

   Prepare the way with hairspray. One time you are happy with your wig, mist it all over one last time with hairspray. Remember to go on the wig on the wig head when you are not wearing it.

   Advertisement

Add together New Question

• Question

  If I do this to my hair, will I be stronger?

  

  Maybe! You lot never know until you lot effort!

• Question

  Will people brand fun of me?

  

  Information technology is possible, only if they do, yous should never let someone's opinion or harsh words bother y'all. Be yourself, and more people will exist likely to like y'all than to ridicule you.

• Question

  Would this make me look gay?

  

  In that location'due south no such thing equally "gay hair," so no, it wouldn't.

• Question

  Volition I be pure hearted?

  

  Having hair like Goku doesn't instantly make you pure-hearted - you'd take to change your beliefs and how you recollect about things. Goku is very naive at times but very gentle with his friends. He's e'er downwardly for some training as well and is very protective over the ones he cares near.

• Question

  Do I practise the same for Vageta's pilus?

  

  Vegeta's pilus is styled differently from Goku's - yous'd have to put the spikes more together and almost straight up. He also lacks bangs and has a very prominent widow's summit.

• Question

  Can girls do this likewise? I am a big fan!

  

  Absolutely! It doesn't thing what gender you are, just have fun with your cosplay and go for it!

• Question

  Tin can yous do this with your ain really long hair?

  

  Possibly, you may or may not need to cut it though. It depends on how long information technology is. If you're willing to cutting it, then become for it!

• Question

  How do you practise a super Saiyan wig?

  

  Yous could either order 1 already set up up similar a Saiyan, or you lot could use some pilus gel/hair spray on a yellow wig and spike it up.

Ask a Question

200 characters left

Include your electronic mail address to get a message when this question is answered.

Submit

Ad

• You could try spiking a mullet-style wig instead, simply yous will not go the exact shape.

• You tin use the techniques outline in this wikiHow to create other hairstyles from the evidence. Simply alter the wig and felt colour, and adjust the spikes to make.

• This wig will get heavy and regular bobby pins may non keep it on your caput. Consider sewing some clips or combs into the wig.

• Make sure that you use a black wig cap under the wig.

• If things offset to go too frustrating, accept a break. Pace away from the wig for a moment, then come up back when you are feeling calmer.

• Proceed the wig on the wig caput. If you are heading off to a convention, identify the whole thing into a box.

• This wig style can be catchy for a beginner. If this is your first time styling such a wig, give yourself enough fourth dimension to brand mistakes and gear up them.

• Become a proficient quality wig and wig wefts. Skip the Halloween story and party store. Go to a costume store or wig shop, or purchase your wig and wefts online.

Thank you for submitting a tip for review!

Advertisement

Things Yous'll Need

• Styrofoam wig head
• Pins
• Black "J-rock" styled wig
• Matching black wig extensions/wefts
• Hairspray
• Pilus drier
• Fabric gum or tacky mucilage
• Low-temp hot glue gun and hot glue sticks
• Arts and crafts foam
• Blackness felt
• Pair of scissors
• Wig cap

Well-nigh This Article

Thank you to all authors for creating a page that has been read 40,652 times.

Did this article help you?

reynoldsappene69.blogspot.com

Source: https://www.wikihow.com/Do-Goku-Hair

Share this post